Your cart is empty.
Your cart is empty.Servicing late model computerized vehicles is more of a challenge today than ever before for the aftermarket automotive service facility. Quite often the difference between being able to effectively and profitably service a car line depends on having access to 'Factory Level' tools and information. At OEMTools we are committed to bringing the 'Best in Class' Tools, Information and Reprogramming to the general aftermarket.
C
July 30, 2025
I liked this tool over others in this size range for the "S" arms allowed for greater bore range. For this tool, 13/16" - 2 1/4". Tool worked as required. Instructions for use were on the back of packaging. List of "cautions" also printed on back of packaging. With reference to bad review because of broken stone. Do not know all facts, but there are ways to break the tool, so go to YouTube and watch a few videos before use.
pschlosser
May 4, 2025
This is not a delicate tool, but it isn't bullet proof, either. As it should be, since it hones tiny little cylinders.Removing the tool from the cylinder while it's still spinning on the drill can damage it. Be gentle with it, and it will last.The last of these I ordered just arrived broken. The blister packaging shows signs of crushing. It was shipped in a padded envelope, which won't offer much protection against boxes and flat mail piled onto it during shipping. I think Amazon fulfillment is responsible for this damage, not the maker of the product.edit: amazon has great service, and the return policy allows for a replacement. it arrived, today... in a padded envelope. but it wasn't crushed and broken, this time! so your luck may vary.I can find nothing on the packaging that stipulates the item it made in the USA. Sold/marketed in the USA, sure. And I have several of their other tools, and they are top notch. Also, they have a lifetime warranty. Knowing this, I don't think it matters where it's made.
Norris Huddleston
February 6, 2025
Smooth side to my chainsaw cylinder
Joe Pianka
December 29, 2024
The stones are trash.... 3 minutes of use and they are mush. You'd be lucky to hone plastic with this thing....
Mike Wheeler
November 11, 2024
Bought this to hone out the barrel on an impact. Did the job beautifully. Nice easy to use unit. Good deal too!
Recommended Products
