Shopping Cart

Your cart is empty.

Your cart is empty.

Nilight 7.5 Inch Aluminum Housing Tail Light 2 PCS 36LED Red Running Brake Turn Signals Marker Lights Surface Mount IP67 Waterproof for 10-30V RV Camper Trailer Truck Bus Boat

4.8 (5) Write Review
Free shipping on orders over $29.99

$27.35

$ 12 .95 $12.95

In Stock

About this item

  • Super Bright LED: Equipped with 36 pcs ultra bright 2835 SMD LEDs, outputting two levels of brightness red light. High brightness is for brake light/turn signals light. Low brightness is for running light/tail light/marker light. Ensure a better visibility and safety at day and night
  • Aluminum Housing: Compared to plastic shells, aluminum shells can accelerate heat dissipation, improve the service life and performance of the entire light. And there is no need to worry about the bottom shell breaking due to excessive force during installation
  • IP67 Waterproof: The PC lens and aluminum shell are tightly fitted, with an internal sealed waterproof design. At the same time, glue is also added to the wires position on the back. Reaching IP67 waterproof level, lights can be used in rainy and snowy weather without worrying about water ingress
  • Surface Mount: Comes with necessary washers, bolts, and nuts for installation. The installation can be completed in ten minutes. Each light has a foam pad, which can be used to mark the positions that need to be drilled. The foam pad can also effectively protect the surface of the car
  • Widely Used: Fit for almost 10-30V DC Vehicles, such as trucks, trailers, tractors, semi-trailer, horse trailer, travel trailer, dump Truck, camper, RVs, bus, boat, special vehicle, etc


Nilight 7.5Inch Aluminum Housing Red Tail Light

LED Type and Quantity: 36 pcs 2835 SMD LEDs

LED Color: Red

Waterproof Rate: IP67 Waterproof

Working Voltage: 10-30V DC (fit for 12/24V DC vehicles)

Wire and Functions: White is for Ground, black is for running light and marker light. And red is for brake light and turn signals light

Package Include: 2 pcs tail light and foam pads, hardware pack


Customer
July 12, 2025
Very happy with the build quality and intensity. Very low profile. There are only two very minor negatives: 1) no written instructions, but the wire colors do follow trailer standards with white being the ground path. 2) this is a pass through design, not a surface mount, so you must have a hole to pass the wires through, but the did provide a good gasket to provide a weather seal.
Joe H.
June 22, 2025
I was impressed that the backing plates were made of aluminum and not plastic. The lens is of course plastic but it's a really thick plastic. I tested the lights using a 9 volt battery and they worked well and were super bright. The red wire was brighter because it's for brake lights and the black wire is for running lights so it was slightly dimmer. The package came with the lights, foam backing pads and the screws/washers/nuts to install it. Drill a few holes and it should easily mount on my trailer. I'm happy.
TM4512
June 12, 2025
The size and slim profile appealed to me, so I took a chance and found that I will likely order another set and double them up on each side!Here are my thoughts:Came quickly and were packaged very well. Instructions were clear and legible. Install was simple and required MUCH less than a traditional LED trailer light. They look great!It is alleged that these are waterproof, and I will say that they certainly appear to be sealed. But only time will tell.They are surprisingly bright for the low profile (smaller SMD chips.)I did not use the included hardware to install as I found that using stainless self-tapping screws would likely last longer in the end.Pictures show parking lights on and then brake lights on. I am very happy with these!I highly recommend!
Lazy I
May 2, 2025
High visibility. Really durable. No issues with water. Easy three wire installation.
Courtney
December 1, 2024
Very solidly constructed. Install easily. Five stars.