Your cart is empty.
Your cart is empty.BENNET RETROFIT TRIM TAB KIT12V
Millertyme
July 16, 2025
I replaced my existing Lenco actuators and these fit perfectly. I was pleasantly surprised when I opened the box and saw that had the two actuators with cables (already attached) as well as the transom and trim tab brackets and deutsch connectors. The connector was easy to install and made connecting into the existing boat wiring very quick.Have only used them a couple times so far, but they are working well, just the way the actuators should work.
Jean-Philippe Tremblay
June 14, 2025
Fonctionne très bien. Facile d’installation.Très satisfait du produit et du vendeur. Reçu rapidement.Remplacer un des mes cylindres de mes trim tab qui ne fonctionnait plus
Customer
May 11, 2025
These fit perfectly and worked as expected.
iraklis mavraeidis
April 20, 2025
sorry but i din not use i will fit on a boat at 2021 THANKS.
Alejandro V.
March 24, 2025
Perfecto servicio.
Travis Becker
January 21, 2025
I had a Bennett hydraulic pump system on my boat that had failed. I bought this kit and it was a drop in replacement. All items required were included. Two actuators, brackets, and bolts. Some jumpers were included for wiring but I did not need them.You are required to re-use the bottom brackets that mount to the existing trim tabs, but the kit includes new retainer pins if needed.The existing hole in the transom from your fluid lines is sealed with a rubber compression gromet on the back of the upper bracket. This works well.I had an existing four wire connector on the inside where the old pump was located. Red/blue/yellow/green and a separate power/ground wire I no longer needed.I cut the pump side connector to re-use to connect directly to both the actuators (wht/blk pairs), Make sure you shrink wrap the wires to prevent corrosion.I also re-used a dual switch I had up on the dash but re-wired according to the attached diagram I found on internet.This was a fairly easy installation, the first actuator took some extra time to figure out but the second actuator installed in 5-10 minutes.One note: The kit states that your old Bennett system must be "4 ring" to work. This can be identified by how many rings are around your old actuators. Right on the cylinders there are 3 or 4 rings. I had 4 rings and it was plug and play.
Yunior C.
December 10, 2024
What iblike about it is that it was a easiest thing to do, no cutting grinding or anything else, just take the old ones out and put the new one back on, hassle free 😉
B. Ocean
November 25, 2024
Easy to install
Recommended Products
