Your cart is empty.
Your cart is empty.
Specification:
Dimension: 114mm*44mm*30mm [4.48*1.73*1.18 inches]
Input: AC100-240V AC 50/60Hz
Output: DC 12V
Output Current, Full Load: 5A
Power: 60W
Material: PVC
Certification: CE, CB, FCC, ROHS
Operating Temperatures: -40 ~ +55degree
Safer Design
DC 12V LED transformer is thermal overload, over current, over-voltage and short circuit protection built-in. The Overpressure protection and Over-heat protection chipset can protect it from burning out. Lightweight, low heat to ensure electrical safety.
Wide Applications
12V power supply is ideal for low voltage LED applications, they can be used in kitchen cabinets or under counters, bars, closets, living rooms, industrial, indoor lights, etc.
The terminals are screw-clamp type
Just strip off 3/16" of insulation from each wire, insert the wire into the appropriate terminal hole and tighten down the screw.
Warning: This power supply is Not dimmable, NOT waterproof.
Mikepit
June 23, 2025
Line feed size is too tight to get the cover on. Would say, max 18ga power supply for better fit.
Woodhouse
June 13, 2025
I got this to replace a 4 year old identical [but differently named] driver that powers 2 x 6 ft strings under cabinet lights that stopped working. These lights are on about 16 hours every day but I expected the driver to last longer than it did though its 2 companion drivers are still OK. The screw clamps that hold the power in lines are very small and fiddly especially if you are attaching solid in-wall wires in it.I am overall very happy with the performance.
CD
May 31, 2025
The media could not be loaded.
Roger Baxter
May 29, 2025
I was impressed by the small footprint of this LED driver/transformer. Of course it is limited to just 60 watts of 12 volt output, but that is adequate for most individual lighting applications around the home - and keep in mind that the actual load should be kept below 80% of that rated output (or roughly 50 watts) for longevity reasons.And I am impressed by the safe and secure method of attaching both input wires and output wires - a screw clamp terminal block which is then covered by a screw down shield. Of course this requires the user to provide both the high voltage line power cord and plug, but it also avoids the output connections made to short pig-tails on the low voltage side (often seen in competitive products).Another impressive feature of this product is the inclusion of a complete wiring diagram that even first time users can easily follow.
jerry
February 27, 2025
CONNECTED PROPERLY TO LED LIGHT, AND NOTHING.
Recommended Products
