Your cart is empty.
Your cart is empty. Sorbothane vibration isolators are versitile spacers that can be used as feet, stops and protectors in many applications. The unique Sorbothane urethane is a durable, resilient, polymer that provides outstanding vibration isolation and non-skid properties. Sorbothane isolators help absorb impact and noise and have excellent resistance to aging; they will not harden or crack over time. They feature a smooth, clean, black urethane surface. Use them on any audio and electronic equipment to prevent skipping and interference. This washer can be combined with Sorbothane Part Number 0510002 or 0510005 to form a complete bushing.
Caution: This product contains plasticizer which may cause minor discoloration to wood, plastic, composite and other materials following prolonged contact.
B. Dalizu
June 15, 2025
I originally purchased this to use on my old car as the dashboard hurt the ride quality even after fitting new tires and suspension components. I decided to use these and fit it behind my dash where the giant bolts held the dash onto the frame. It did wonders! It eliminated 90% of my problems. I now find myself using it on my computer fans and hard drives. I will be buying more of these. Highly recommended.
Patrick R.
May 4, 2025
Great product, great service.
Shed
April 17, 2025
Brilliant, do the job well
Aly
April 15, 2025
Vibration issue: Geothermal ground loop pipe, attached to ceiling joists via 2 inch pipe clamps (U shaped).Washer plus matching bushing, used to reduce vibration transfer from pipe to ceiling joists. Reduced vibration transfer by about two thirds to three quarters. Well worth doing.Washer: Sorbothane Part Number: 0510001-50Bushing: Sorbothane Part number : 0510005-30Fender Washer: 3/16 x 1.25 inch (you actually need a 1 inch diameter but this is what was in stock)Could only get a 30 duro bushing, there were no exact matching 50 duro, even on Isolate-It's website. These are the officially matching items.You need a separately purchased fender washer as the sorbothane material is so soft. The screw head would not hold the washer + bushing together, instead sinking into the material. The fender washers I purchased allowed clearance around the screw head/shaft.When the pipe vibrates, the pipe clamp conveys that movement to the fender washer + sorbothane washer + bushing, absorbing most of the vibration. Only a small amount of vibration makes it through to the ceiling joist.
marcus38
December 29, 2024
Just installed with the counterpart bumpers but, have not powered up the fans to comment on isolation. I do recommend the use of fender washers with these very soft Sorbothane washers else, they will tear and you will not be able to get them to hold in place. They are expensive so, best to be careful during installation.
Recommended Products
$95.72
$ 43 .91 $43.91