Your cart is empty.
Your cart is empty.Product Description
There is only one plate in the package and the winch is not included.
HRT
July 31, 2025
Well built, fits a SmittyBilt 9500 winch perfectly!
Rock
July 23, 2025
This winch mount is good Quality for the medium duty application. It came packaged ok. Fit and finish was good and looks good on my truck.
Bert
July 20, 2025
10k smittybilt fits tight but still fits. Only bad thing i can say is the packaging was a bit poor. The handle bars was rubbing against the main piece and scratched the paint of out of it. Some foam or cardboard between the pieces would be nice
Kirk Misick
July 16, 2025
I gave this product 4 stars because I couldn't use my receiver sleave due to the gusset on the tail of the cradle not being long enough to line up the holes for the pin. So as a result of that, the cradle is loose inf the hitch because I have a bigger hitch receiver. Other than that ,it will work.Made very well !
brian hays
July 16, 2025
Installed on a 10,000lb winch, used on a Tractor, worked great
jg cyr
July 6, 2025
This is really a good mount winch fits perfectly in and good quality
Anthony taylor
July 3, 2025
Good
Glenn W.
June 26, 2025
I haven't had a chance to use it yet but it looks to be well built. I plan to use it for my car trailer so I can remove the winch when not in use and so I can but it in the truck receiver if I need to get a different angle.
Builder Guy in Days Gone by
May 14, 2025
Considered purchasing one at HF since our winch is their 12,000 lb one. Picked up the box and was astounded by how light it was. Looked inside and said no way does this last, and I highly doubt it is for 9000 lbs. So I looked elsewhere and ran across this, with a whole lot of positive reviews. When rating for 13,000 lbs I expected heft and strong welds. I was pleased to see I got both. Took a few minutes to assemble (would have been shorter but I goofed and put the upright handle on the left and the lower one on the right - when looking from the back side). After that was fixed a little grinding of the lower side of the cable pathway just in case, as noted by others, and it was ready. Bolts and locking nuts are 11/16 and everything turned out quite well. Quality product. I have no idea how this could get a low rating when you consider ones charging twice as much are no better than this one.
robochick
April 13, 2025
The media could not be loaded.
Kimberly B.
March 28, 2025
Works great plates on the back side were a little too long but easy to fix
Jay Lark
February 15, 2025
The winch was a Harbor Freight Badland 12,000 lb synthetic. The thickness of the steel is okay. The accuracy of the holes for the bottom of the winch as well as the fairlead were off almost a quarter inch. I just used a carbide burr and directed the holes to where I needed them to go.The plates in front and behind the main plate are welded at an angle so it'll make the winch tighter.Also check, the handle lengths hhare asymmetric, so put it which way works best for your winch.
Peter
January 4, 2025
The measurements in the pictures are a bit different and I was worried it wouldn't fit my Harbor Frieght 12K pound winch. I took a chance and it fits perfectly! Holes align! Looks to be welded good.
Recommended Products
$67.38
$ 27 .35 $27.35