Your cart is empty.
Your cart is empty. Size :M10x1.0 - 31.7mm
It includes 4 pcs Brake Bleeder Screws
With 4 pcs Dust Caps
High Quality and Easy Installation
Adam Drummond
August 7, 2025
I tightened these as much as I could and still shot out fluid. They do not work at all tried all 4
Uhh...
August 3, 2025
Like the pre-sealed threads, easy to install. Works as expected. I would like to see better dust caps. Like the OG ones for the calipers had little ribbed rings that make it easier to grip and remove, especially with dirty, greasy hands.
Nicole W
May 15, 2025
The thread fit is so loose it makes bleeding brakes impossible. Do not buy. It made the job way harder than it should be. I couldn’t even drain the system once I realized they don’t work because you can’t suck fluid out due to the thread issue. I now have to order new fittings and try to change them with fluid in the line. Brake fluid leaking everywhere is awesome!!!! I’m sick of all the cheap crap these hucksters sell. I know there are versions and brands out there that do work, But it isn’t this foreign junk. Most likely made by people who don’t know what a brake is. Lesson learned. I’d give zero stars if possible.
Brian Jorgenson
May 4, 2025
Don't buy this product if you expect an actual speed bleeder. These are just regular replacement brake bleed ports.
WheezerMF
March 20, 2025
The product description on these is inadequate. The crucial measurement on these is from the base of the ‘nut’ to the tip of the cone that seals the system. These only described overall length, which was within the acceptable range. I installed them, and while the nut did bottom out, the tip never sealed. The OEM bleeder valves are 20 mm from the nut to the tip, and these are only 15mm. My picture shows the OEM part next to the new ones (shinier), and the difference is pretty obvious. Unfortunately, I was dealing with dripping brake fluid and didn’t put them side-by-side before I installed it.I went for a test drive, and sprayed a quart of brake fluid all over the rear end of the car. My brakes completely failed and I had to use emergency brake and first gear to get stopped, even rolling slowly into the garage. Also, it ruined my brake pads, both the regular disc pads, and the drum pads for the emergency brake. What a Fustercluck!!
Shawn O'Donnell
January 6, 2025
I use these to bleed all four corners on my 2001 Chevrolet Camaro. Just like the instructions State quarter of a turn pump the brakes till no more air bubbles tighten them back up. Was able to successfully bleed all four corners by myself.
Recommended Products
