Shopping Cart

Your cart is empty.

Your cart is empty.

Dremel Max Life 9901Hp 1/8' (3.2Mm) Tungsten Carbide Rotary Carving Bit

4.3 (8) Write Review
Free shipping on orders over $29.99

$9.75

$ 5 .03 $5.03

In Stock
  • Dremel's line of Max Life high-performance accessories provide long-lasting performance and impressive durability. Built to give you longer lasting, stronger performing, versatile accessories.
  • The Max Life 9901HP Tungsten Carbide Carving Bit is coated in titanium nitride and is engineered to last 2X longer than the standard, non-coated Dremel 9901 carving bit.
  • The tungsten carbide bits can be used for more aggressive applications to shape, smooth, or grind hard materials such as metals, hardened steel, fire ceramics, cast iron, plastics, and hardwoods.
  • The cylinder shape of the carving bit allows for deep removal of material, cuts flat areas, round edges and makes stop cuts and v-cuts
  • Ideal for projects like metal or glass engraving, stone carving, or removing flash from castings
  • The accessory tip makes flat-bottom slots and grooves, flat side cuts, and makes v-cuts when held at 45-degrees


Dremel's line of Max Life high-performance accessories provide long-lasting performance and impressive durability. Built to give you longer lasting, stronger performing, versatile accessories. The Max Life 9901HP Tungsten Carbide Carving Bit is coated in titanium nitride and is engineered to last 2X longer than the standard, non-coated Dremel 9901 bit. For use with all Dremel high-speed rotary tools, the 1/8 In. (3.2 mm) accessory can be used for more aggressive applications to shape, smooth, or grind hard materials such as metals, hardened steel, fire ceramics, cast iron, plastics, and hardwoods. The carving bit works well for projects like metal or glass engraving, stone carving, or removing flash from castings. The cylinder shape of the carving bit allows for deep removal of material, cuts flat areas, round edges and makes stop cuts and V-cuts. The accessory tip makes flat bottom slots and grooves, flat side cuts, and makes V-cuts when held at 45-degrees. 1 rotary accessory included.


Customer
July 23, 2025
I use it for everything. I ordered a second one.
Hany E
July 20, 2025
Good product
JB
July 7, 2025
Using to create thumb hole in hardened steel knive blades.
Ahmed Al-Blooki
June 1, 2025
Good product
Tennessee Phil
May 12, 2025
This bit is small enough to get into tight spaces, and it works well for both wood and metal. Recently I had to work on a door striker plate whose opening didn't extend quite far enough for the latch to extend into the hole. A few minutes of grinding with this bit opened it enough to let the door close easily.
shehab saeed
March 12, 2025
all good
Julio T.
February 25, 2025
El artículo llegó a tiempo y en buenas condiciones.Gracias.
AJ
December 27, 2024
What I liked most about this bit is that it has stayed sharp for a long time. I am a welder/fabricator so I use it to shape steel and grind on welds that are in tight spaces. What I didn't like about the bit was that it was pretty short and any dremel that has the cup around the collet makes it difficult to lay the bit flat to get an even cut. I recommend this bit for all uses but make sure to use the correct speed and pressure. If it shoots sparks that's too much pressure, and if it chatters a lot then increase your speed. It produces a ton of small sharp shavings so make sure to where the proper PPE while using this bit.