Your cart is empty.
Your cart is empty.Length (Inches) (Inch): 11-Inch Finish On Handle(S): Red Vinyl Grip. Forms Tabs To Secure Vinyl Siding
Jack Roberts
July 16, 2025
Gets the job done and great value for the money
Jason
June 29, 2025
Worked good, I used it for clipping into undersil trim.I used undersil trim at the top of my siding and also under large windows.
Oxford Metal
June 26, 2025
Great for making nail slots. A bit tricky to get nice jtrim cleats without breaking through the siding.
Hotrod
May 19, 2025
This tool comes in handy when you are running the siding horizontally and reach the top of a wall. It puts a small tab bending out at 90 degrees in the cut edge of the siding. This you repeat every 8". Its sufficient to stop the siding pulling out of the finishing trim it goes into.
Dan
March 30, 2025
I’m redoing the siding on my house. This tool is simple but great. You will need this if you’re doing vinyl siding. It locks the top piece of siding in place nicely.
Dominic Robillard
March 26, 2025
Useful
Rob
March 20, 2025
Suited for 1" J-chanel so keep that in mind for ¾ J-Chanel that you will need to punch closer to the edge than the tools let you to. Price comparable to everywhere else.
Kostas
January 4, 2025
Bought it based on great reviews. Handle bent and spring busted after 3 connections. Material and craftsmanship sub par in my opinion. You get what you pay for...
Chad D. Mamerow
December 5, 2024
Simple tool, but it worked great. Completed siding on my entire house and this helped. Longer handle makes it user to use, so on the long pieces, your hand doesn't get tired.
Bob
December 3, 2024
Worked like a champ and very easy!
Kacey Green
December 1, 2024
I don't know if I did it right or if it had the desired effect, but the siding is still where I put it.
Ziji
November 18, 2024
Works well for making tabs along top edge of fascia in order to attach it into the undersill trim. It WILL punch all the way through the fascia in thinner spots, leaving a hole, rather than a tab, as stated in other reviews.. I found that it works just as well to use it to make a bump in the fascia, rather than punching all the way through to make a tab. The undersill trim will hold the fascia very firmly with only bumps. I know this because I had to take the fascia back down after installing it.. Was very difficult to remove from undersill trim..
Rebecca
November 13, 2024
I do home repairs. A couple times in the last year I needed to finish the last top row of siding and these allow me to make a slot/bump that locks in the last piece.
Recommended Products
