Your cart is empty.
Your cart is empty.Product Description
Speed：
- 0.8-1RPM
- 2.5-3RPM
- 5-6RPM
- 10-12RPM
- 15-18RPM
- 20-24RPM
- 30-36RPM
This speed is NOT a precise value, this motor is not suitable for precision instruments such as clocks.
Specification:
- Shaft Diameter: 7mm ；
- Shaft Length: 16mm；
- Voltage : AC 12V；
- Power : 4W；
- Frequency : 50/ 60Hz；
Direction：
There are three types of motor steering：
- CW;
- CCW;
- CW/CCW(UNCONTROLLABLE)
Small Power Consumption
Minimum power 4W.
Low noise, Good Quality
Metal-plastic hybrid gear, less noise, quieter motor operation.
Small Size, Big Torque
Motor length 57.5mm, thickness 20.8mm. High torque for DIY.
Easy to Install
Small weight, easy to install and use.
Customer
May 28, 2025
I had to extend the shaft with a custom bushing I made but restored the oscillation of my fan. Very happy about that.
Stéph
April 13, 2025
Ce n’est pas un produit qui va dans un foyer électrique le petit moteur va souter, il n’es pas fait pour ça
Vicki Johnson
February 15, 2025
Exactly what I needed for fiber optic tree
kenneth roberts
February 14, 2025
i used this motor for color wheel in childs fish tower and it worked very well ken from pa.
Gene Magnee
December 25, 2024
I ordered this as a replacement for the oscillator motor in a Bionaire heater, as all of the numbers / specs. matched the original that has a stripped gear set. After waiting almost 2 months for it to arrive (I assume due to the pandemic), I received it and wired it into the heater. Before even connecting the mechanical linkage, I turned on the heater and activated the oscillation to test. The motor began turning, but emitted a grinding noise. Within 5 seconds, a bright flash of light came from the heater's circuit board and the motor stopped. The motor's housing was already quite warm for as briefly as it ran, indicating it was over loaded and drawing far too much current, which is what fried the drive circuit on the PCB. My heater is now permanently non-oscillating.....
Robert Hentschel
November 17, 2024
Casing fit perfectly. Had to modify the output shaft from round to a "D" style, but I knew that going in. Met all of my expectations.
Customer
November 10, 2024
Purchased two 2.5-3 rpm motors, to have a spare, to replace a 10-12 rpm motor that I purchased two years ago that was working fine but wanted to try a slower spin rate for our large hanging ornament. Both of these motors burned out within three seconds of plugging them in. No ornament was attached, just a test run. I wired the faster motor back in and it continues to run just fine. I didn’t add a photo because they look fine and that doesn’t convey the acrid smell of burned plastic/metal. A waste of time and money.
Recommended Products
$21.59
$ 9 .35 $9.35
$20.91
$ 10 .07 $10.07