Shopping Cart

Your cart is empty.

Your cart is empty.

Allstar ALL48010 1/8' NPT Inlet/Outlet Manual Brake Shut-Off Valve

Free shipping on orders over $29.99

$69.84

$ 28 .79 $28.79

In Stock

About this item

  • Brake shut-off valve is a manual type with a 1/8 npt inlet and outlet
  • Valve has a 2,000 psi rating
  • Shut off valve measures 1/2 inch wide x 1-3/4 inch long x 1-9/16 inch tall
  • Sold each
  • Backed by a 90-day limited factory warranty


Allstar 1/8 inch NPT Inlet/Outlet Manual Brake Shut-Off Valve is a manual type with a 1/8 npt inlet and outlet. The valve has a 2,000 psi rating. The shut off valve measures 1/2 inch wide x 1-3/4 inch long x 1-9/16 inch tall. It is backed by a 90-day limited factory warranty and sold individually.


ron h.
June 18, 2025
Installed this on my forklift. Works amazing! Easy to install, just needed the two 1/8 th npt to 3/16 ths flared fittings . Very happy with this.
TramShadyCustoms
June 12, 2025
Great product using it on the front brakes of my one Ton jeep for winch and holds really well no problems and great price you will need 3/16 fare to 1/8 npt adapters
Andy L-Cyr
May 31, 2025
It leaks after a couple weeks. using it on a car rear brakes line. Use it just to be able to get out of the vehicule a couple minutes when the car run. It doesnt hold real mutch pressure. Forget that in a hill.
hemooax
March 21, 2025
Construcción robusta, previamente compre uno marca empi, no funciono y fugo!!!. Este es otro boleto. Muy bueno.Saludos
paul
February 20, 2025
Used as rear brake line lock as parking brake . Holds nice.
WRP
January 21, 2025
The perfect item for my intended use: I just completed a break install on a small home built trailer this weekend using a surge coupler and a 3/4-ton truck axle. I installed this valve in-line so that, in the event of a failure, I could turn off the brakes between the coupler and the brake drums. Also allows me to back the trailer without fussing with the 'reverse lockout' handle on the surge coupler.
gerald williams
January 18, 2025
this work great and turns easy hold fluid great i have had two of those that summit sell with the pullout knob had it on it locks and the only way to move was to loosen fitting to let pressure out they will replace them and leave you with the mess of fluid in your floor board to smell. gerald
Stacy
December 10, 2024
Used for rear disc brake conversion on a Toyota. Holds perfect on a flat surface. It will bleed down overnight. I don’t depend on it for obvious reasons. Does work as I expected.